You can then enter this IP address in your internet browser so that the web page is displayed. When the code is downloaded to the microcontroller, open the serial monitor to find out the IP address. Libraries #include // //Parameters String request unsigned long refreshCounter = 0 int status = WL_IDLE_STATUS char ssid = '****************' char password = '****************' //Objects WiFiServer server(80) WiFiClient client void setup () Result client.print() to send data to the client.client.read() to read data from the client.WiFiClient client = server.available() to initialize a client.WiFi.begin() to initiate a network connection.To interact with the Shield Wifi, we use the WiFi.h library whose functions to know are the following: The WiFi module must be connected to the network.This protocol is integrated in all libraries related to WiFi communication. To communicate on the network, we need to use a special protocol.

the SPI bus: pins 11,12,13 on an Arduino UNO/Duelmilanove card.

10 for selection of microchip W5100 (W5100_CS).

4 for the selection of the SD card (SD_CS).

Pin 10 is used to select the WiFi controller, pin 7 as handshake between the Arduino and WiFi and pin 4 to select the SD card module. The Wifi shield mounts directly on the Arduino card and uses the SPI bus to communicate with the WiFI and SD card. If you are using an ArduinoSeeeduino card you can only stack the WiFi badge on the board.You must not misuse or interfere with the Services or try to access them using a method other than the interface and the instructions that we provide.By default you would have the actual device you are building HOST peer-to-peer WIFI connection over an.

Arduino wifi shield ad hoc network